Zebra WT6000 Series User Manual

DataWedge Configuration
85
Reader Params
Allows the configuration of parameters specific to the selected bar code reader.
• Adaptive Scanning - The RS4000 contains the adaptive scanning feature that automatically adjusts the
scan beam width for rapid and easy scanning of bar codes from near contact to more than 200 inches
away. When the user presses the trigger, the RS4000 determines the distance from the bar code. For
close bar codes the RS4000 sets a wide beam width and for far bar codes it sets a narrow beam width.
The RS4000 uses distance, bar code type and material to determine the correct scan beam width.
Options: Enable or Disable. (RS4000 only).
• Beam Width - Selects the beam width of the scanner. Options: Narrow, Normal or Wide (RS4000 only).
• 1D Quiet Zone Level - Sets the level of aggressiveness in decoding bar codes with a reduced quiet zone
(the area in front of and at the end of a bar code), and applies to symbologies enabled by a Reduced Quiet
Zone parameter. Because higher levels increase the decoding time and risk of misdecodes, Zebra strongly
recommends enabling only the symbologies which require higher quiet zone levels, and leaving Reduced
Quiet Zone disabled for all other symbologies (RS5000 and RS6000 only). Options are:
• 0 - The scanner performs normally in terms of quiet zone.
• 1 - The scanner performs more aggressively in terms of quiet zone (default).
• 2 - The scanner only requires one side EB (end of bar code) for decoding.
• 3 - The scanner decodes anything in terms of quiet zone or end of bar code.
• Aim mode - Turns the scanner cross-hairs on or off (RS507, RS5000 and RS6000 only).
• On - Cross-hair is on (default).
• Off - Cross-hair is off.
• Character Set Selection -
• ISO-88959-1 - part of the ISO/IEC 8859 series of ASCII-based standard character encodings. It is
generally intended for Western European languages.
• Shift_JIS - Shift Japanese Industrial Standards (JIS) is a character encoding for the Japanese
language.
• UTF-8 - A character encoding capable of encoding all possible characters, or code points, defined by
Unicode (default).
• Time Delay to Low Power - Sets the time the decoder remains active after decoding. After a scan
session, the decoder waits this amount of time before entering Low Power Mode. Options: 1 Second
(default), 30 Seconds, 1 Minute or 5 Minutes.
• Illumination Brightness - Sets the brightness of the illumination by altering LED power. The default is 10,
which is maximum LED brightness. For values from 1 to 10, LED brightness varies from lowest to highest
level of brightness (RS507/RS6000 only).
• Illumination mode - Turns imager illumination on and off. This option is only available when Bluetooth
Scanner is selected in the Barcode input, Scanner selection option (RS507, RS5000 and RS6000 only).
• On - Illumination is on.
• Off - Illumination is off (default).
• Inverse 1D Mode - This parameter allows the user to select decoding on inverse 1D bar codes (RS507,
RS5000 and RS6000 only).
• Disable - Disables decoding of inverse 1D bar codes (default).
• Enable - Enables decoding of only inverse 1D bar codes.
• Auto - Allows decoding of both twice positive and inverse 1D bar codes.

Zebra WT6000 Series Specifications

General

Brand	Zebra
Model	WT6000 Series
Category	Handhelds
Language	English