Corrective Maintenance
Printhead Cables
168
14207L-001 A ZM400/ZM600 Maintenance Manual 8/9/07
Printhead Cables
Tools Required
1.
2.
Tools • You need these tools to complete this procedure:
 Phillips Screwdriver Set
 Metric Nutdriver Set
 Metric Hex Key (Allen wrench) Set
 Antistatic Wrist Strap and Pad
 47362* Zebra Preventive Maintenance
Kit
* In place of the Preventive Maintenance Kit, you may use clean swabs and a solution containing
isopropyl alcohol (≥ 90%) with deionized water (≤10%).
Caution • Turn off (O) the printer and disconnect it from the power source before
performing the following procedure.
Caution • While performing any tasks near an open printhead, remove all rings,
watches, hanging necklaces, identification badges, or other metallic objects that could
touch the printhead.
Open the media door and remove the media and ribbon.
To Next Page
Loading...
Need help?
General
