Operations
Control Panel Parameters
78
14207L-001 A ZM400/ZM600 Maintenance Manual 8/9/07
Standard Printer Parameters
Table 12 shows parameters in the order in which they are displayed when you press PLUS (+)
after entering Setup mode.
Table 12 • Printer Parameters (Page 1 of 24)
Parameter Action/Explanation
Adjust Print Darkness
Darkness (burn duration) settings depend on a variety of factors, including
ribbon type, media type, and the condition of the printhead. You may adjust
the darkness for consistent high-quality printing.
Important • Set the darkness to the lowest setting that provides
good print quality. If the darkness is set too high, the ink may
smear, the ribbon may burn through, or the printhead may wear
prematurely.
If printing is too light or if there are voids in printed areas, increase the
darkness. If printing is too dark or if there is spreading or bleeding of
printed areas, decrease the darkness.
The FEED Self Test on page 120 can be used to determine the best darkness
setting. You may want to adjust darkness while performing the PAUSE Self
Test on page 119. Because the darkness setting takes effect immediately,
you can see the results on labels that are currently printing. Darkness
settings also may be changed by the driver or software settings.
Default Value (ZPL, XML): +10
Range (ZPL, XML): 00 to +30
Default Value (EPL): +7
Range (EPL): 00 to +15
To change the value shown:
1. Press SELECT to select the parameter.
2. Press
PLUS (+) to increase darkness.
3. Press
MINUS (-) to decrease darkness.
4. Press SELECT to accept any changes and deselect the parameter.
To Next Page
Loading...
Need help?
General
