•
Remove the oil seal (10).
Disassembling the clutch
To remove the clutch, proceed as follows:
•
Carefully and progressively unscrew
the three screws (1) securing the thrust
plate following the order A-B-C.
CAUTION
PAY CAREFUL ATTENTION WHILE LOOSENING AND
TIGHTENING THE THREE SCREWS (1). ALWAYS PRO-
CEED GRADUALLY AND PROGRESSIVELY ON EACH
SCREW.
•
Remove the thrust plate (2).
•
Remove the three springs (3).
RS 660 - Tuono 660 Engine
ENG - 171