•
Insert the safety plate (5).
Steering bearing
Adjusting play
•
Place the vehicle so that the front wheel is off the ground.
•
Carry out a handlebar rotation test, using a dynamometer at the hand grip external end.
•
The handlebar resistance to rotation must be of 250 +/- 100 g (0.55 +/- 0.22 lb) in both
directions.
•
Adjust if clearance is detected.
NOTE
THE STEERING COLUMN RESISTANCE TO ROTATION MUST BE PERFORMED IN THE TWO
OPPOSITE ROTATION DIRECTIONS.
•
Loosen the fixing screws (1) of the
stanchions.
•
Unscrew and remove the fixing bush
(2) of the upper clamp.
RS 660 - Tuono 660 Suspensions
SUSP - 259
To Next Page
Loading...
Need help?
General
