•
After having adequately protected the
calliper, connect the brake hose, the
special screw (3) and tighten it to the
prescribed torque.
•
Fill with oil and bleed the system.
•
Check the correct functioning of the braking system
Front brake calliper
Removal
NOTE
THE FOLLOWING OPERATIONS REFER TO A SINGLE BRAKE CALLIPER BUT ARE VALID FOR
BOTH.
To remove the front brake calliper, it is necessary
to previously drain the braking system.
•
Remove the protection cap (1) of the
bleed valve and free the wiring harness
of the front ABS sensor (if present).
•
Make sure you have a container with
adequate capacity to recover the oil,
suitably protect the brake calliper and
after connecting a pipe to the breather
valve (2), unscrew it to allow the oil to
drain out and empty the system.
Braking system RS 660 - Tuono 660
BRAK SYS - 346
To Next Page
Loading...
Need help?
General
