Setting Transmission Functions
5-30
Setting and Storing Custom Fax Settings
5
NOTE
•
To cancel the setting procedure, press “Cancel.”
3
Press “Done.”
The specified mode is set.
Press “Done” repeatedly until the Fax Basic Features screen appears.
Setting the Pause Time
This section describes how to set the pause time (in seconds).
Some overseas dialing may not be successful due to the distance or complex route for
connections when you dial the international access code, country code, and the destination
number all together. In such cases, insert a pause after the international access code. Then
the machine dials the number with a short waiting time where the pause is inserted, which
helps improve the connection.
NOTE
•
You can insert a pause on the Fax Basic Features screen. (See ‘Specifying Destinations Using
Numeric Keys,’ on p. 2-19.)
•
Pauses entered at the end of dialed telephone numbers are always 10 seconds long.
•
The default setting is “2 (sec).”
1
Call up the desired screen as follows:
2
Set the pause time using “-” or “+,” and press “OK.”
The pause time must be from 1 to 15 seconds in one-second increments.
You can also input the value using - (numeric keys).
(Additional
Functions)
Pause Time
Index.book Page 30 Thursday, May 24, 2001 12:30 AM
To Next Page
Loading...
Need help?
General
