2
Selecting the Sending Method
2-17
Basic Fax Usage
Stamping Sent or Scanned Originals (Stamping Original)
The machine can print a stamp about 1/8" (3mm) in diameter on the front side of scanned or
sent originals. You can set the Stamp mode to differentiate scanned or sent originals.
NOTE
•
Stamping originals can be set when the Feeder (DADF-H1) is attached.
•
When sending an original directly, you can set the machine so that the original is stamped either
after it has been sent, or after it has been scanned. (See ‘Setting the Stamping Conditions,’ on p. 5-
33.)
1
Place your originals in the feeder.
For instructions explaining how to set the original, see ‘Sending an Original,’ on p. 2-7.
2
Make sure the machine is ready to send, and press “Stamp.”
A tick “ ” appears in the box to the left of “Stamp.”
ABC
ABC
Vertical placement
Horizontal placement
Position at which
stamp is applied
Position at which
stamp is applied
Index.book Page 17 Thursday, May 24, 2001 12:30 AM
To Next Page
Loading...
Need help?
General
