Activity Management Reports and Lists
9-4
Appendix
9
Multiple Communication Result Report
This report is used to check whether documents were sent normally to the intended
destination when a sequential broadcast transmission was performed.
You can set whether or not to automatically print a sending result report after sending
documents by fax. (See ‘Setting Automatic Output of a TX Report,’ on p. 7-3.)
NOTE
•
The default setting for printing of the TX result report is “For error only.”
•
You can also print a TX report with an image of the sent original attached to it. (See ‘Setting
Automatic Output of a TX Report,’ on p. 7-3.)
1 JOB NO.
A 4-digit number, that is automatically assigned when the sending document is
accepted, is printed.
2 PGS.
The number of pages of the original that were normally sent to the remote party is
printed.
3
DEPARTMENT ID
If Department ID Management is set, the Department ID is printed.
4 TX/RX
INCOMPLETE
The telephone number of the sending destination to which you have not finished
sending is printed. If there is no applicable destination, “_ _ _” is printed.
5
TRANSACTION
OK
The telephone number of the sending destination to which you have finished sending
is printed. If there is no applicable destination, “_ _ _” is printed.
6 ERROR
When a sending error occurs, the telephone number of the sending destination is
printed. If there is no applicable destination, “_ _ _” is printed.
0014
1
[ 11] 1234567890
-----
[ 10] 0987654321
Canon CANADA
Canon U.S.A
03/05 2001 MON 13:43 FAX 035 4892 5997 CANON
JOB NO.
PGS.
TX/RX INCOMPLETE
TRANSACTION OK
ERROR
.
001
✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽
✽✽✽ ✽✽✽
✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽
MULTI TX/RX REPORT
Multi TX/RX Report
Index.book Page 4 Thursday, May 24, 2001 12:30 AM
To Next Page
Loading...
Need help?
General
