An internet module must be available for sending e-mails and a GSM modem is necessary for sending
SMS. See the Communications chapter for more information.
6.14.7 Alarmlist
Alarmlist is a container of active and inactive alarms. It will appear automatically on the controller
display, if a new alarm occurs, or can be displayed manually from the display menu
ï‚· It can contain up to 16 alarms, but the first 7 are visible on the screen. If it is full, recently
coming alarms are not displayed.
ï‚· Active alarms are shown as inverted, not yet confirmed alarms are marked with asterisk
before them.
ï‚· An alarm message in the alarmlist begins with a prefix, which represents the alarm type
(e.g. WRN). Then the alarm name follows. In some cases the prefix can be omitted.
NOTE:
The Alarmlist can be read out from the controller via Modbus. See the Modbus description chapter.
6.14.8 ECU Alarmlist
The ECU Alarmlist contains alarms that are received from the ECU. The alarms are represented by
the Diagnostic Trouble Code, which contains information about the subsystem where the alarm
occurred, the alarm type and the alarm occurrence counter.
The most common fault codes are translated into text form. Other fault codes are displayed as a
numeric code and the engine fault codes list must be used to determine the reason.
NOTE:
The ECU AlarmList is visible only if an ECU is configured.
To Next Page
Loading...
Need help?
General
