InteliCompact
NT
, SW version 2.1
InteliCompact-NT-2.1-Reference Guide.pdf, ©ComAp – May 2015
Setpoint: TelNo/Addr Ch1
Setpoint: TelNo/Addr Ch2
16.1.13 Group: AnalogSwitches
Setpoint: AnaSwitch1 ON
Limits and units depend on analog input configuration
Threshold level for switching ON the analog switch assigned to the analog
input 1 of the controller.
Enter in this setpoint either a valid GSM phone number or e-mail address
where the alarm messages shall be sent.
NOTE:
For GSM numbers use either the national format (i.e. the number you would
dial if you wanted to make a local call) or the full international format
beginning with a “+” character followed by the country prefix.
NOTE:
This setpoint can be modified from a PC only!
Enter in this setpoint either a valid GSM phone number or e-mail where the
alarm messages shall be sent.
NOTE:
For GSM numbers use either the national format (i.e. the number you would
dial if you wanted to make a local call) or the full international format
beginning with a “+” character followed by the country prefix.
NOTE:
This setpoint can be modified from a PC only!
To Next Page
Loading...
Need help?
General
