PAGE button. Use this button to switch across display pages. See the next
chapter for details about display pages and screens structure
5.2 User interface modes
The user interface consists of two modes:
User mode allows the user to go through all screens with measurements and alarms. The
button does not work, i.e. setpoints and history pages are not accessible.
Engineer mode gives qualified personnel full access to all pages and screens.
See the chapter User interface mode selection to learn how to change the user interface mode.
5.3 Display screens and pages structure
The displayed information is structured into “pages” and “screens”. Use the button to switch
over the pages.
1. The Measurement page consists of screens which display measured values like voltages,
current, oil pressure, etc. and computed values such as gen-set power, statistic data and the
alarm list on the last screen.
2. The Setpoints page contains all setpoints organized into groups and also a special group for
entering the password.
3. The History log page shows the history log in order with the last record displayed first.
NOTE:
The picture below shows the structure of displayed data. The contents of each particular screen may
be slightly different according to the firmware branch and version.
To Next Page
Loading...
Need help?
General
