11.5 IC-NT-RD Remote display software
IC-NT-RD is remote display software for an InteliCompact
NT
controller. Remote display provides the
same control and monitoring functions as controller itself (except limitations given by HW differences
between remote display and controller). Remote display for IC-NT controllers uses standard IL-NT
controller platform with IC-NT Remote display software. No further programming of the display is
required – unit is self configurable from the main controller. It is connected with the controller via
IL-NT-RS232 communication modules using RS232 line. Longer distances (up to 1200m) are possible
using IL-NT-RS232-485 communication module or when RS232/RS485 converters are used.
NOTE:
In case of IL-NT-AMF25 HW only Bus under voltage LED (indicating if the bus is under voltage or
not/if the Load is supplied or not) is missing. This information is anyway given by combination of GCB
and MCB position LEDs placed on the right and left side next to the Bus under voltage LED.
The other IL-NT hardware types have other limitations according to HW variations from IC-NT HW.
HINT:
IC-NT RD SW works analogically to IL-NT RD SW. See IC-NT RD SW website to find out more
information about installation and configuration.
To Next Page
Loading...
Need help?
General
