11.3.5 System integration
The controller can be integrated into a building management or similar system using an RS232,
RS485 or Ethernet interface and MODBUS protocol. The following modules can be used for this
purpose:
1. IL-NT RS232
2. IL-NT RS232-485
3. IB-Lite (Modbus/TCP)
The setpoint COM1 Mode (RS232) resp. COM2 Mode (RS485, Ethernet) must be set to the MODBUS
position. The speed of MODBUS communication for RS232 and RS485 can be adjusted by the
setpoint ModbusCommSpeed. See a more detailed description of the MODBUS protocol in a separate
chapter.
NOTE:
The controller is able to detect IB-Lite module and performs automatic configuration. Related setpoints
COM1 Mode = DIRECT; COM2 Mode = MODBUS; ModbusCommSpeed = 57600 (THIS APPLIES TO
FIRMWARE VERSIONS 2.0 AND HIGHER).
11.3.6 InternetBridge-NT setup procedure
See the latest InternetBridge-NT Reference Guide for the information on how to set up the IB-NT
module.
11.3.7 IG-IB setup procedure
See the latest InteliCommunicationGuide for the information on how to set up the IG-IB module.
11.3.8 SNMP
Support for Simple Network Management Protocol was implemented. To generate MIB table go to
LiteEdit 4.6 or higher and use “Controller” -> “Generate Cfg image” -> “Generate SNMP MIB table”.
11.3.9 AirGate
technology for easy plug-and-play wireless communication is incorporated into the product. An
ordinary SIM card with GPRS service is suitable for this system. This overcomes problems with the
necessity for a special SIM card (fixed and public IP), firewalls and difficult communication settings.
http://www.comap.cz/news-room/news-and-events/detail/AirGate
http://www.comap.cz/news-room/news-and-events/detail/The-Rainbow-rises-for-remotemonitoring-
applications/
11.3.10 Locate
The controller supports the technology for GSM localization using an IL-NT-GPRS
communication module. It is possible to view the localization in WebSupervisor.
To Next Page
Loading...
Need help?
General
