NOTE:
The ECU AlarmList is visible only if an ECU is configured.
5.8 Entering the password
A password must be entered prior to adjusting setpoints that are password-protected. The password is
located in the first group of setpoints and the method to enter or change the password is similar to
changing setpoints as described in the setpoints chapter.
NOTE:
It is possible to change only passwords of the same or lower level than the currently entered
password!
NOTE:
Lost password? Display the information screen which contains the serial number and a password
decode number as described in the chapter below. Write down both numbers and send a request to
retrieve the password to your local distributor containing these two numbers. You can also save and
send an archive instead.
5.9 Controller information screen
1. Press the button repeatedly until you will see the main controller screen with the mode
selector and kW analog meter.
2. Hold down the button and simultaneously press the button to see the controller
information screen.
3. The information screen will disappear automatically after 5 seconds.
4. Press the button again within 5 to switch to the language selection screen.
5. Press the button again to switch to the user interface mode selection screen. This
screen also contains the serial number and password decode number.
6. Pressing the button next switches back to the information screen.
7. Press the button to get back to the controller main screen.
To Next Page
Loading...
Need help?
General
