InteliCompact
NT
, SW version 2.1
InteliCompact-NT-2.1-Reference Guide.pdf, ©ComAp – May 2015
Value: Running Q-Pwr
Value: Running NomPwr
Sum of nominal power of all gen-sets within the group that are connected to
the bus and are performing the power management, i.e. that are in AUT
mode and have power management enabled.
Sum of nominal load of all active gen-sets within the group.
This value shows the current priority number. If the binary input Top Priority
is active, the priority number will be 0, otherwise the value will correspond to
the setpoint Priority. See the chapter Power management for details.
The values show which gen-sets (controller CAN addresses) are running in
current active power band.
Sum of reactive power of all gen-sets within the group that are connected to
the bus and are performing the power management, i.e. that are in AUT
mode and have power management enabled.
To Next Page
Loading...
Need help?
General
