EasyManuals Logo
Home>Dell>Switch>PowerConnect 3548

Dell PowerConnect 3548 User Manual

Dell PowerConnect 3548
474 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
Introduction 21
VLAN Supported Features
VLAN Support
VLANs are collections of switching ports that comprise a single broadcast domain. Packets are classified
as belonging to a VLAN based on either the VLAN tag or based on a combination of the ingress port and
packet contents. Packets sharing common attributes can be grouped in the same VLAN.
For more information, see "Configuring VLANs."
Port Based Virtual LANs (VLANs)
Port-based VLANs classify incoming packets to VLANs based on their ingress port.
For more information, see "Defining VLAN Ports Settings."
Full 802.1Q VLAN Tagging Compliance
IEEE 802.1Q defines an architecture for virtual bridged LANs, the services provided in VLANs, and the
protocols and algorithms involved in the provision of these services.
GVRP Support
GARP VLAN Registration Protocol (GVRP) provides IEEE 802.1Q-compliant VLAN pruning and
dynamic VLAN creation on 802.1Q trunk ports. When GVRP is enabled, the device registers and
propagates VLAN membership on all ports that are part of the active underlying "Spanning Tree
Protocol Features" on page 21 topology.
For more information, see "Configuring GVRP Parameters."
Private VLAN Edge
Ports can be assigned to Private VLAN Edge (PVE) groups. A port defined as PVE is protected by an
uplink, so that it is isolated from other ports within the same VLAN. The uplink must be a GE port.
For more information on Private VLANs, see "Configuring Ports" on page 297.
Spanning Tree Protocol Features
Spanning Tree Protocol (STP)
802.1d Spanning tree is a standard Layer 2 switch requirement that allows bridges to automatically
prevent and resolve L2 forwarding loops. Switches exchange configuration messages using specifically
formatted frames and selectively enable and disable forwarding on ports.
For more information, see "Configuring the Spanning Tree Protocol."

Table of Contents

Other manuals for Dell PowerConnect 3548

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerConnect 3548 and is the answer not in the manual?

Dell PowerConnect 3548 Specifications

General IconGeneral
MAC address table8000 entries
Maximum data transfer rate0.1 Gbit/s
Supported data transfer rates10/100 Mbps
10G support-
Number of VLANs256
Flow control supportYes
Networking standardsIEEE 802.1D, IEEE 802.1p, IEEE 802.1Q, IEEE 802.1s, IEEE 802.1w, IEEE 802.3ad
Dimensions (WxDxH)440 x 257 x 43.2 mm
Networking featuresGigabit Ethernet, Fast Ethernet
Authentication methodRADIUS, TACACS+
Connectivity technologyWired
Switch typeManaged
Switch layerL2
Data link protocolsEthernet
Supported network protocolsHTTP, HTTPS/SSL, SSH
Power connectorDC-in jack
SFP/SFP+ slots quantity2
Basic switching RJ-45 Ethernet ports quantity48
Product colorBlack
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 45 °C
Storage relative humidity (H-H)10 - 95 %
Operating relative humidity (H-H)10 - 90 %
Weight and Dimensions IconWeight and Dimensions
Weight8000 g

Related product manuals