276 Configuring Switch Information
Configuring Locked Port Security with CLI Commands
The following table summarizes the equivalent CLI commands for configuring Locked Port security as
displayed in the Port Security page.
The following is an example of the CLI commands:
ACL Overview
Access Control Lists (ACL) allow network managers to define classification actions and rules for specific
ingress ports. Packets entering an ingress port, with an active ACL, are either admitted or denied entry
and the ingress port is disabled. If they are denied entry, the user can disable the port.
This section contians the following topics:
• "Defining IP based ACLs" on page 277
• "Defining MAC Based Access Control Lists" on page 283
• "Defining ACL Binding" on page 286
Table 7-4. Port Security CLI Commands
CLI Command Description
shutdown Disables interfaces.
set interface active {ethernet interface | port-
channel port-channel-number}
Reactivates an interface that is shutdown due to
port security reasons.
port security learning {disabled | dynamic}
Defines the locked port type.
port security max max-addr
Specifies the number of MAC address that
can be learned on the port.
port security [forward | discard | discard-
shutdown] [trap seconds]
Locks learning of new addresses on an interface.
show ports security {ethernet interface | port-
channel port-channel-number}
Displays port lock status.
console # show ports security
Port Status Action Trap Frequency Counter
----- ------- ------- ------- --------- --------
1/e1 locked Discard Enable 100 88
1/e2 locked Discard,
Shutdown
Disable
1/e3 Unlocked - - - -
To Next Page
Loading...
Need help?
General
Weight and Dimensions
