Configuring Switch Information 369
Displaying Protocols Assigned to Ports
1
Open the
Protocol Port
page.
2
Click
Show All
.
The
Protocol Based VLAN Table
opens.
Figure 7-59. Protocol Based VLAN Table
Defining Protocol Ports Using CLI Commands
The following table summarizes the equivalent CLI command for defining Protocol Ports.
Table 7-31. Protocol Port CLI Commands
The following example sets a protocol-based classification rule of protocol group 1 to VLAN 8:
Configuring GVRP Parameters
GARP VLAN Registration Protocol (GVRP) is specifically provided for automatic distribution of VLAN
membership information among VLAN-aware bridges. GVRP allows VLAN-aware bridges to
automatically learn VLANs to bridge ports mapping, without having to individually configure each
bridge and register VLAN membership.
To ensure the correct operation of the GVRP protocol, it is advised to set the maximum number of
GVRP VLANs equal to a value which significantly exceeds the sum of:
• The number of all static VLANs both currently configured and expected to be configured.
• The number of all dynamic VLANs participating in GVRP, both currently configured (initial number of
dynamic GVRP VLANs is 128) and expected to be configured.
CLI Command Description
switchport general map
protocols-group group
vlan vlan-id
Sets a protocol-based classification rule.
Console (config-if)# switchport general map protocols-group 1
vlan 8
To Next Page
Loading...
Need help?
General
Weight and Dimensions
