Configuring Switch Information 389
Enabling IGMP Snooping on the device
1
Open the
Global Parameters
page.
2
Select
Enable
in the
IGMP Snooping Status
field.
3
Click
Apply Changes
.
IGMP Snooping is enabled on the device.
Enabling Multicast Filtering and IGMP Snooping Using CLI Commands
The following table summarizes the equivalent CLI commands for enabling Multicast Filtering and IGMP
Snooping as displayed on the
Global Parameters
page.
The following is an example of the CLI commands:
Adding Bridge Multicast Address Members
The Bridge Multicast Group page displays the ports and LAGs attached to the Multicast service group
in the Ports and LAGs tables. The Port and LAG tables also reflect the manner in which the port or
LAGs joined the Multicast group. Ports can be added either to existing groups or to new Multicast
service groups. The Bridge Multicast Group page permits new Multicast service groups to be created.
The Bridge Multicast Group page also assigns ports to a specific Multicast service address group.
To open the Bridge Multicast Group page, click Switch → Multicast Support → Bridge Multicast Group
in the tree view.
Table 7-38. Multicast Filtering and Snooping CLI Commands
CLI Command Description
bridge multicast filtering Enables filtering of Multicast addresses.
ip igmp snooping Enables Internet Group Membership
Protocol (IGMP) snooping.
console(config)# bridge multicast filtering
console(config)# ip igmp snooping
To Next Page
Loading...
Need help?
General
Weight and Dimensions
