Dell PowerConnect 3548 User Manual

194 Configuring System Information
Assigning Line Passwords Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the Line
Password page.
The following is an example of the CLI commands:
Defining Enable Passwords
The Enable Password page sets a local password to control access to Normal and Privilege levels.
To open the Enable Password page, click System → Management Security → Enable Passwords in the
tree view.
Figure 6-69. Enable Password
The Enable Password page contains the following fields:
• Select Enable Access Level — Access level associated with the enable password. The lowest user access
level is
1 and 15 is the highest user access level. Users with access level 15 are Privileged Users, and only
they can access and use the OpenManage Switch Administrator.
•
Password (0-159 characters) — The password to enable.
Table 6-39. Line Password CLI Commands
CLI Command Description
password password
[encrypted]
Indicates a password on a line.
console(config-line)# password dell

Dell PowerConnect 3548 Specifications

General

MAC address table	8000 entries
Maximum data transfer rate	0.1 Gbit/s
Supported data transfer rates	10/100 Mbps
10G support	-
Number of VLANs	256
Flow control support	Yes
Networking standards	IEEE 802.1D, IEEE 802.1p, IEEE 802.1Q, IEEE 802.1s, IEEE 802.1w, IEEE 802.3ad
Dimensions (WxDxH)	440 x 257 x 43.2 mm
Networking features	Gigabit Ethernet, Fast Ethernet
Authentication method	RADIUS, TACACS+
Connectivity technology	Wired
Switch type	Managed
Switch layer	L2
Data link protocols	Ethernet
Supported network protocols	HTTP, HTTPS/SSL, SSH
Power connector	DC-in jack
SFP/SFP+ slots quantity	2
Basic switching RJ-45 Ethernet ports quantity	48
Product color	Black
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	10 - 95 %
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Weight	8000 g