Dell PowerConnect 8024 User Manual

Configuring SNMP 299
Configuring Communities
Beginning in Privileged EXEC mode, use the following commands to
configure access rights for SNMPv1 and SNMPv2.
show snmp group
[
group_name ]
View SNMP group configuration information.
show snmp user
[ user_name ]
View SNMP user configuration information.
Command Purpose
configure Enter Global Configuration mode
snmp-server community
string [ro | rw | su]
[view
view-name ]
[ipaddress
ip_address ]
Configure the community string and specify access criteria
for the community.
• community-string — Acts as a password and is used to
authenticate the SNMP management station to the
switch. The string must also be defined on the NMS in
order for the NMS to access the SNMP agent on the
switch (Range: 1-20 characters)
•
ro — Indicates read-only access
•
rw — Indicates read-write access.
•
view-name — Specifies the name of a previously defined
MIB view.
• ip_address — Specifies the IP address of the management
station. If no IP address is specified, all management
stations are permitted
Command Purpose

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries