Dell PowerConnect 8024 User Manual

876 Configuring DHCP Server Settings
Deleting Excluded Addresses
To remove an excluded address:
1
Open the Network Properties page.
2 Click Delete Excluded Addresses to display the Delete Excluded
Addresses
page.
3 Select the check box next to the address or address range to delete.
Figure 32-4. Delete Excluded Addresses
4 Click Apply .
Address Pool
Use the Address Pool page to create the pools of IP addresses and other
network information that can be assigned by the server.
To display the Address Pool page, click Routing
→ IP → DHCP Server →
Address Pool in the navigation panel.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries