Dell PowerConnect 8024 User Manual

810 Configuring Data Center Bridging Features
Default DCB Values
Table 29-2 lists the default values for the DCB features that this chapter
describes.
DCBx Allows DCB devices to exchange configuration information, using
type-length-value (TLV) information elements over LLDP, with
directly connected peers.
FIP Snooping Inspects and monitors FIP frames and applies policies based upon
the L2 header information in those frames
ETS Supports the ETS configuration and Application Priority TLVs,
which are accepted from auto-upstream devices and propagated to
auto-downstream devices. In support of FIP snooping, the 8024
switch only transports the ETS TLVs and does not configure itself
with received ETS information. The PC8132/PC8164 switches
support the automatic configuration of the switch with received
ETS parameters.
Table 29-2. Default Port-Based Traffic Control Values
Feature Default
PFC Disabled, no priority classifications are
configured.
DCBx version Auto detect
FIP snooping Disabled globally and on all VLANs
FC map value 0x0efc00
FIP snooping port mode Host facing (not FCF facing)
Table 29-1. Data Center Features (Continued)
Feature Description

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries