Dell PowerConnect 8024 User Manual

Managing Images and Files 317
Active Images
Use the Active Images page to set the firmware image to use when the switch
boots. If you change the boot image, it does not become the active image
until you reset the switch.
To display the Active Images page, click System
→ File Management →
Active Images in the navigation panel.
Figure 14-2. Active Images
NOTE: On the PC8000-series switches, the images are named image1 and
image2 . On the PC8100-series switches, the images are named active and
backup .

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries