EasyManuals Logo

Dell PowerConnect 8024 User Manual

Dell PowerConnect 8024
1294 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #793 background imageLoading...
Page #793 background image
Configuring Link Aggregation 793
This provides a more resilient LAG. Best practices suggest using dynamic link
aggregation instead of static link aggregation.When a port is added to a LAG
as a static member, it neither transmits nor receives LACP PDUs.
What is LAG Hashing?
PowerConnect 8000/8100-series switches support configuration of hashing
algorithms for each LAG interface. The hashing algorithm is used to
distribute traffic load among the physical ports of the LAG while preserving
the per-flow packet order.
The hashing algorithm uses various packet attributes to determine the
outgoing physical port.
The switch supports the following set of packet attributes to be used for hash
computation:
Source MAC, VLAN, EtherType, and incoming port.
Destination MAC, VLAN, EtherType, and incoming port.
Source IP and Source TCP/UDP port numbers.
Destination IP and Destination TCP/UDP port numbers.
Source/Destination MAC, VLAN, EtherType, and incoming port.
Source/Destination IP and Source/Destination TCP/UDP port numbers.
Enhanced hashing mode
Enhanced hashing mode has following advantages:
MODULO-N operation based on the number of ports in the LAG.
Packet attributes selection based on the packet type. For L2 packets,
Source and Destination MAC address are used for hash computation. For
IP packets, Source IP, Destination IP address, TCP/UDP ports are used.
Non-Unicast traffic and Unicast traffic is hashed using a common hash
algorithm.
Excellent load balancing performance.

Table of Contents

Other manuals for Dell PowerConnect 8024

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerConnect 8024 and is the answer not in the manual?

Dell PowerConnect 8024 Specifications

General IconGeneral
Switching Capacity480 Gbps
StackableYes
Device TypeSwitch
Enclosure TypeRack-mountable
Power RedundancyOptional
Width17.3 in
Height1.7 in
Jumbo Frame SupportYes
Ports24 x 10 Gigabit SFP+
ManagementWeb-based GUI, Command Line Interface (CLI), SNMP
VLAN SupportYes
Power SupplyInternal
Routing ProtocolStatic routing
FeaturesQuality of Service (QoS), VLAN support
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature0 to 45 °C
Storage Temperature-20 to 70 °C
Relative Humidity10% to 90% (non-condensing)
MAC Address Table Size32, 000 entries

Related product manuals