Dell PowerConnect 8024 User Manual

546 Configuring Access Control Lists
7 Verify the configuration.
console#show ip access-lists web-limit
IP ACL Name: web-limit
Inbound VLAN(s):
100
Rule Number: 1
Action............................ deny
Match All......................... FALSE
Protocol.......................... 6(tcp)
Source IP Address................. any
Destination IP Address............ any
Destination L4 Port Keyword........ 80(www/http)ip
Time Range Name....................work-hours
Rule Status....................... inactive
Configuring a Management Access List
You can create a management access list that contains rules to apply to one or
more in-band ports, LAGs, or VLANs to limit management access by method
(for example, Telnet or HTTP) and/or source IP address.
NOTE:
Management ACLs cannot be applied to the OOB port.
Management Access List Commands
Beginning in Privileged EXEC mode, use the following commands to create a
management access list. There is an implicit deny-all rule at the end of every
management ACL. This means that any host that does not meet the criteria
defined in a permit command is denied access to the management interface.
NOTE: Management ACLs can be applied only to in-band ports and cannot be
applied to the OOB port.
Command Purpose
configure Enter Global Configuration mode.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries