To Next Page

To Previous Page

304 Configuring SNMP

SNMP Configuration Examples

This section contains the following examples:

• Configuring SNMPv1 and SNMPv2

• Configuring SNMPv3

Configuring SNMPv1 and SNMPv2

This example shows how to complete a basic SNMPv1/v2 configuration. The

commands enable read-only access from any host to all objects on the switch

using the community string

public

, and enable read-write access from any

host to all objects on the switch using the community string

private

This example also shows how to allow the switch to generate traps for all

features that produce traps. The traps are sent to the host with an IP address

of 192.168.3.65 using the community string

public

To configure the switch:

Configure the public community string.

console#configure

console(config)#snmp-server community public ro

Configure the private community string.

console(config)#snmp-server community private rw

Enable all traps and specify the IP address of the host where the traps

should be sent.

console(config)#snmp-server enable traps all

console(config)#snmp-server host 192.168.3.65

public

console(config)#exit

View the current SNMP configuration on the switch.

console#show snmp

Community-String Community-Access View Name IP Address

-------------------- ---------------- --------- -------

private Read/Write Default All

public Read Only Default All

Dell PowerConnect 8024 User Manual

Other manuals for Dell PowerConnect 8024