Dell PowerConnect 8024 User Manual

Configuring SNMP 303
snmp-server v3-host { ip-
address
| hostname }
username {traps |
informs} [noauth | auth
| priv] [timeout
seconds ] [retries retries ]
[udpport
port ] [filter
filtername ]
For SNMPv3, configure the system to receive SNMP traps
or informs.
• ip-address — Specifies the IP address of the host
(targeted recipient).
• hostname — Specifies the name of the host. (Range: 1-
158 characters.)
•
username — Specifies user name used to generate the
notification. (Range: 1-25 characters.)
•
traps — Indicates that SNMP traps are sent to this host.
•
informs — Indicates that SNMPv2 informs are sent to
this host.
• noauth — Specifies sending of a packet without
authentication.
•
auth — Specifies authentication of a packet without
encrypting it
•
priv — Specifies authentication and encryption of a
packet.
• seconds — Number of seconds to wait for an
acknowledgment before resending informs. This is not
allowed for hosts configured to send traps. The default is
15 seconds. (Range: 1-300 seconds.)
•
retries — Maximum number of times to resend an inform
request. This is not allowed for hosts configured to send
traps. The default is 3 attempts. (Range: 0-255 retries.)
•
port — UDP port of the host to use. The default is 162.
(Range: 1-65535.)
• filter-name — Specifies the optional filter (defined with
the
snmp-server filter command) to use for the host.
(Range: 1-30 characters.)
exit Exit to Privileged EXEC mode.
show trapflags View the status of the configurable SNMP traps.
Command Purpose

Dell PowerConnect 8024 Specifications

General

Brand	Dell
Model	PowerConnect 8024
Category	Switch
Language	English