Dell PowerConnect 8024 User Manual

566 Configuring VLANs
Default VLAN Behavior
One VLAN is configured on the PowerConnect 8000/8100-series switches by
default. The VLAN ID is 1, and all ports are included in the VLAN as access
ports, which are untagged. This means when a device connects to any port on
the switch, the port forwards the packets without inserting a VLAN tag. If a
device sends a tagged frame to a port with a VLAN ID other than 1, the frame
is dropped. Since all ports are members of this VLAN, all ports are in the same
broadcast domain and receive all broadcast and multicast traffic received on
any port.
When you create a new VLAN, all trunk ports are members of the VLAN by
default. The configurable VLAN range is 2–4093. VLANs 4094 and 4095 are
reserved.
Ports in trunk and access mode have the default behavior shown in Table 22-2
and cannot be configured with different tagging or ingress filtering values.
When you add a VLAN to a port in general mode, the VLAN has the behavior
shown in Table 22-6.
Table 22-6. General mode Default Settings
Feature Default Value
Frames accepted Untagged
Incoming untagged frames are classified into the VLAN
whose VLAN ID is the currently configured PVID.
Frames sent Untagged
Ingress Filtering On
PVID 1

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries