Dell PowerConnect 8024 User Manual

Configuring Data Center Bridging Features 829
FIP Snooping Configuration Example
In this example, FIP snooping is deployed on a stack of two PowerConnect
switches that are functioning as enterprise data center top of rack (ToR)
switches. Two 10G ports on each stack member (ports 16 and 17 on each
switch) connect to a pair FCoE-facing switches through redundant links.
These ports are designated as default DCBx auto-upstream ports. The 10G
interface interface Enter interface configuration mode for the specified
interface. The
interface variable includes the interface type
and number, for example tengigabitethernet 1/0/3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
tengigabitethernet 1/0/8-12 configures interfaces 8, 9, 10,
11, and 12.
fip-snooping port-mode
fcf
Configure the interface to be connected to a FCF switch.
CTRL + Z Exit to Privileged EXEC mode.
show fip-snooping
sessions
Display information about the active FIP snooping
sessions.
show fip-snooping fcf
[
fcf-mac ]
Display information about the interfaces connected to
Fibre Channel forwarder (FCF). Use the optional fcf-mac
parameter to display additional information about the
session with the specified FCF device.
show fip-snooping
enode [
enode-mac ]
Display information about the interfaces connected to
FCoE end nodes (ENodes). Use the optional enode-mac
parameter to display FIP snooping sessions between the
given FCF-MAC and ENode-MAC.
show fip-snooping
statistics {vlan
vlan_id |
interface
interface }
Display the statistics of the FIP packets snooped for all the
FIP snooping-enabled VLANs or for the specified VLAN or
interface. FIP session establishment sends some packets
on the native VLAN (which are counted on the interface)
and some packets on the FCoE VLAN (which are counted
in the VLAN).
clear fip-snooping
statistics {vlan
vlan_id |
interface
interface }
Clear the statistics of the FIP packets snooped for all the
FIP snooping-enabled VLANs or for the specified VLAN or
interface.
Command Purpose

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries