Dell PowerConnect 8024 User Manual

Configuring IP Routing 915
show ip route [ ip-address
[
mask | prefix-length ]
[longer-prefixes] |
protocol ]
View the routing table.
• ip-address — Specifies the network for which the route
is to be displayed and displays the best matching best-
route for the address.
•
mask — Subnet mask of the IP address.
•
prefix-length — Length of prefix, in bits. Must be
preceded with a forward slash (‘/’). (Range: 0-32 bits)
•
longer-prefixes — Indicates that the ip-address and
subnet-mask pair becomes the prefix, and the command
displays the routes to the addresses that match that
prefix.
•
protocol — Specifies the protocol that installed the
routes. (Range:
connected, ospf, rip, static )
show ip route configured View the configured routes, whether they are reachable or
not.
show ip route summary View summary information about the routing table.
show ip protocols View the parameters and current state of the active
routing protocols.
show ip route preferences View detailed information about the route preferences.
Command Purpose

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries