Select the Pickup Type
In our example preset we use a single coil pickup,but want it to sound like a double coil humbucker.
1. With the Wah-Pickup LED lit,rotate Knob 3 until the display reads
SC>Humb. This makes a single
coil pickup sound like a humbucker.
Turn the Compressor Off
We don’t use compression in our preset so,we need to turn the Compressor off. To turn the
Compressor off,do the following:
1. Press the EFFECT SELECT DOWN button. The Compression LED lights and the display
shows the current status of the Compressor.
2. If the Compressor is on,press the STATUS button until the red display reads off (
Of).
Turn the Whammy
™
/IPS/Talker
™
Off
We don’t want Whammy, IPS, or Talker effects in this preset. To turn these effects off,do the
following:
1. Press the EFFECT SELECT DOWN button, and the Whammy/IPS/Talker LED is lit.
2. If the display indicates that one of these effects is active, press the STATUS button until the
display reads off (
Of).
Turn the Stompbox Modeling Off
To turn the Stompbox Modeling off for this preset, do the following
1. Press the EFFECT SELECT DOWN button until the Stompbox LED is lit.
2. If the display indicates that it is active, press the STATUS button until the display reads off (
Of).
1. Rotate Knob 3 until
To Next Page
Loading...
Need help?
General
