Storing a Preset
Once you have modified the Amp Models,Cabinet Types, and Effect Parameters, the Store Button LED flashes
indicating you have changed a parameter and need to store the changes to a User Preset location or to a
Compact Flash Card Preset location in order to recall them later. The following steps outline the procedure
for storing a preset:
1.Press the STORE button.The first letter of the preset name begins flashing.
2.Use the DATA WHEEL to select the alpha-numeric character.
3.Press the NEXT button to select the next character to the right,and the PREV button to select the
previous character to the left.
4.Repeat steps 2 and 3 until you are finished naming the new preset.
5.Press the STORE button again.The current preset location will then flash in the red display.
6.Select the User or Card Preset location using the DATA WHEEL.
7.Press the STORE
button again to finish.
Copying a Preset
To copy one preset to another preset location, begin by selecting the preset you want to copy,then
follow the steps listed above.
Press EXIT at any time during the procedure to abort the store process.
6. Select a User or
5. Press Store Again
7. Press Store Again
3. Use the Next button
1. Press Store
2. Use the Data Wheel to select an
To Next Page
Loading...
Need help?
General
