Adjust the Noise Gate
For our example,we want our Noise Gate to open quickly with a relatively weak signal. This type of
gate uses the Silencer
™
with a low threshold and short attack time. To create this type of Noise Gate,
do the following:
1. Press the AMP FOOTSWITCH to select the Channel 2 Amp (
CH2 AMP),our high gain model.
(The GNX4 must be in Stompbox/Control mode to complete this function.)
2. Press the EFFECT SELECT DOWN button and the Noise Gate’s LED lights.
3. If the display reads off (
Of),press the STATUS button until the display reads on (On).
4. Rotate Knob 1 until the display reads
SILeNCeR for the type of gate.
5. Rotate Knob 2 to set the Threshold to
15 (this may need to be adjusted depending upon your
guitar).
6. Rotate Knob 3 to set the Attack Time to
0 (fast attack).
Select and Adjust the Chorus
Next we wanted to thicken up the sound,by adding a subtle Chorus effect, in the following manner:
1. Press the EFFECT SELECT DOWN button again and the LED in the Chorus/Mod row lights.
2. If the display reads off (
Of),press the STATUS button until the display reads on (On).
3. Rotate Knob 1 until the display reads Chorus (
Chorus) for the effect type.
4. Rotate Knob 2 to set the Chorus Speed to
5.
5. Rotate Knob 3 to set the Chorus Depth to
30.
6. Rotate Knob 4 to set the PreDelay to
1.
7. Rotate Knob 5 to set the Chorus Level to
50.
Turn the Delay Off
To bypass the Delay, do the following:
1. Press the EFFECT SELECT DOWN button until the LED in the Delay row lights.
2. If the display reads on (On),press the STATUS button until the display reads off (Of).
1. Press Effect
2. Press the Status Button to
3. Rotate Knob 1
4. Rotate Knob 2
Speed to 5.
5. Rotate Knob 3
Depth to 30.
6. Rotate Knob 4
to 1.
7. Rotate Knob 5
Level to 50.
To Next Page
Loading...
Need help?
General
