78
The GNX4’s 8-Track Recorder
Playing Back a Recorded Track
After a track is recorded, playing it back is simple.If you are at the end of the track or the song,press the
PLAY button. The recorder automatically begins playing back the track/song from the very beginning. If
you want to start playback at the beginning of a track or song but are someplace other than the end of
the song,follow these steps:
Begin with the Recorder stopped.
1.Press the REWIND button once to move to the beginning of the song.
2.Press the PLAY button. The newly recorded track is automatically armed in PLAY status (the track
button is lit green) and the track begins playing back.
ATTENTION: Do not remove your CF card or turn the GNX4’s power off while playing
back a track or you may lose files.
Recording Multiple Tracks
After a track has been recorded, you may want to record other tracks (overdub) that will play along with
it. You will want to play the previously recorded track(s) as a monitoring source while recording new
tracks. To add a new track to previously recorded tracks do the following:
1.Press the RECORD button. The next available track for recording automatically lights red,indicating it
is armed to record, and the recorder begins recording on this track from the beginning of the song.
The TIME display begins counting off the recording time. If Autostop is turned on,the recorder will
automatically stop when the longest track playing back is finished. If Autostop is turned off, go to step
2.
2.When recording is complete,press the STOP button.
Setting Track Playback Levels and Panning
After a track has been recorded, you can set the pan and playback level for each track. This is done using
the LEVEL and PAN buttons. This feature is most useful if done while the recording is playing back so
you can hear the changes as they are being made. To set level and pan controls for each track, follow
these steps:
2. Press the Play button
1. Press the Rewind button
To Next Page
Loading...
Need help?
General
