Layout Adjustment
129
Fax
4
Reduce/Enlarge (Specifying the Scan Ratio for the Original)
This feature enlarges or reduces a scanned document to a specified ratio prior to
transmission.
Important • Some machines may not be able to receive faxes at the specified ratio.
1 Select [Reduce/Enlarge].
2 Select a preset ratio or specify a
value.
Note • Initial values for ratio other
than [100%] and [Auto %]
can be changed. For more information, refer to "Reduce/Enlarge Presets" (P.323).
• If a magnification is specified in [Reduce/Enlarge], automatic rotation transmission does not
work. For information about the feature, refer to "Rotate 90 degrees" (P.319).
îš„100%
Scanned at the same size as the original.
îš„Auto %
If the scan width of the document is greater than the maximum image size, the
scanned image is rotated or reduced to fit the maximum size.
When speed dialing is used, the maximum image size will be the size registered in
Address Number. When speed dialing is not used, the maximum size will be A3.
You can specify whether to rotate documents in the System Settings. For more information, refer to "Rotate
90 degrees" (P.319).
îš„Variable %
Touch the window displaying a value, and then use the numeric keypad or the [ ] and
[ ] buttons to specify a ratio within the range of 50 - 400% in 1% increments.
Stamp (Adding a Stamp when Scanning a Document)
This feature prints a circular stamp on the bottom corner of each document page when
it is fed through the document feeder. This helps you easily check if the document has
been scanned correctly.
Important • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
• The stamp cannot be added to the following documents:
- Documents placed on the document glass
- Documents suspended by pressing the <Stop> button
- Documents suspended by paper jams
- Single-sided documents greater than 600 mm
- Two-sided documents greater than 431.8 mm
- Documents remaining on the document feeder
- Documents suspended by memory over flow
- Documents that were being scanned when suspending an immediate transmission
1 Select [Stamp].
2 Select [On].
To Next Page
Loading...
Need help?
General
