Print Mode Settings
311
System Settings
11
Other Settings
You can make other settings relating to the paper used in the printer.
Print Area
Set whether to expand the print area.
For information about the printable area, refer to Printable Area (P.546).
Substitute Tray
When there is no tray containing the paper size selected by the automatic tray selection,
select whether or not to print replaced with paper loaded in another paper tray. In the event of
using substitute tray, set the size.
Note • When documents are printed using emulation such as ESC/P and HP-GL/2, this setting is
not valid and a message prompting you to load paper appears on the screen.
îš„Display Message
Does not use a substitute tray, but displays a paper loading message.
îš„Use Larger Size
Replaces with the next larger paper size than that selected, and prints at the same size.
îš„Use Closest Size
Replaces with the closest paper size to that selected, and prints. If necessary, the printing is
automatically reduced in size.
Note • If there is a client specification, the client specification takes precedence.
îš„Select Tray 5 (Bypass)
Replaces with the paper in the Tray 5 (Bypass).
Paper Type Mismatch
Set the action to be taken when the paper type loaded in the paper tray does not match the
paper type specified.
îš„Print
Prints with the paper loaded in the tray.
îš„Display Confirmation Screen
A confirmation screen appears to show procedures.
If a paper type mismatch occurs during print job processing, the machine ignores the paper
type specified on the print driver and selects another type of paper loaded on the machine.
îš„Display Paper Supply Screen
The [Paper Supply] screen appears, prompting you to load another type of paper in the
selected tray. The print job can be processed if you follow the instructions displayed on the
screen.
Note • If you load another type of paper in the tray by following the screen instructions, the paper
type setting for the tray will also be changed to the setting displayed on the screen
automatically.
Unregistered Forms
Set whether to print a job or not if a form specified for printing in a form data file (overlay
printing) is not registered on the machine. If you specify [Print], since the specified form is not
present, only the data is printed.
This setting is added to the print settings menu when there is a print specification from the
host computer.
To Next Page
Loading...
Need help?
General
