11 System Settings
280
System Settings
11
Paper Tray Priority
Set the paper tray priority sequence for automatic tray selection.
Automatic tray selection means that a tray containing the appropriate paper is automatically
selected by the machine for copying or printing.
You can select the Trays 1 to 4. The Tray 5 (Bypass) cannot be selected.
Paper Type Priority
Set the paper type priority sequence for automatic tray selection.
Automatic tray selection means that a tray containing the appropriate paper is automatically
selected by the machine for copying or printing.
You can set plain paper, recycled paper, side 2 paper, and custom paper 1 to 5.
The paper type priority setting takes precedence over the paper tray priority settings.
If different paper types appear in the same priority sequence, the paper selection is
determined by paper tray priority sequence. Selecting [Auto Paper Off] for a paper type
prevents its paper tray from being used by automatic tray selection.
For information about the tray priority sequence, refer to Paper Tray Priority (P.280).
Tray 5 (Bypass) - Paper Size Defaults
Set the paper sizes shown in the [Tray 5 - (Bypass)] screen for [Paper Supply] when copying
with the Tray 5 (Bypass).
You can assign 11 paper sizes to the Tray 5 standard size buttons 1 to 11.
If you frequently use non-standard size paper for copying, assigning the paper size to a
button will save your time to specify the size each time. It is also convenient to set the
commonly used paper sizes toward the top.
îš„A/B Series Size
You can select from sizes of A and B series.
îš„Inch Size
You can select from sizes of inch series.
îš„Others
You can select from other sizes.
îš„Variable Size
You can enter any size. Set the width (X) within the range 99 to 432 mm, and the height (Y)
within the range 89 to 297 mm in 1 mm increments.
Auto Tray Switching
Set the method of auto tray switching when running out of paper loaded in the tray selected.
îš„Enable during Auto Paper
Only when [Auto Paper] is selected for [Paper Supply], the machine automatically selects a
tray containing appropriate paper.
îš„Always Enable
Regardless of which paper tray is selected for [Paper Supply], the machine automatically
selects a tray containing appropriate paper depending on the conditions.
Note • The machine does not switch the tray automatically in the following cases:
• The Tray 5 (Bypass) is selected.
• The tray containing paper other than plain paper, recycled paper, side 2 paper, or Custom1
to Custom 5 paper is selected.
• The tray containing paper that is set as [Auto Paper Off] in [Paper Type Priority] is selected.
To Next Page
Loading...
Need help?
General
