222
Chapter 8 Configuring Hardware and Utilities
8.2.4 Boot Options Submenu
Use this submenu to set system startup options.
table: Items on the Boot Options Submenu
Item Setting Description
POST Errors Halt On All Errors
(Unchangeable)
Sets whether or not to stop the boot process and shut down
the system, in case a POST (Power On Self Test) error is
detected.
Keyboard Check • Disabled
• Enabled (Initial value)
Sets whether or not to check keyboard connection during
POST.
SM Error Halt Enabled (Unchangeable) Sets the procedure in case an error occurs regarding the fan
or temperature sensor.
Fast Boot Disabled (Unchangeable) Sets whether or not to reduce the scope of POST and thereby
speed up system startup.
Quiet Boot Disabled (Unchangeable) Sets whether or not to display the logo screen instead of
POST information.
Boot Menu • Disabled
• Enabled (Initial value)
Sets whether or not to display the boot drive selection
window after POST.
By selecting the boot drive from the [Boot Menu] window,
startup can be done from the selected boot drive regardless of
the [Boot Sequence] setting.
NumLock • Auto (Initial value)
•On
•Off
The state of the NumLock during activation.
MultiBoot for HDs Enabled (Unchangeable) Sets whether or not it is possible to specify the order of hard
disks to boot the operating system (OS) when multiple hard
disk units are installed.
To perform a PXE boot, set to [Enabled].
Item Specific HelpBoot Options
Change Values-/+
F9
Select Item
Select Menu
Select Sub-MenuEnter
F1
Esc
Help
Exit
F7
Mod. Defaults
Previous Values
Advanced Security Server ExitMain
Pause and displays
SETUP entry or resume
boot prompt if error
occurs on boot. If
disabled, system always
attempts to boot.
[Halt On All Errors]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Enabled]
[Auto]
[Enabled]
POST Errors:
Keyboard Check:
SM Error Halt:
Fast Boot:
Quiet Boot:
Boot Menu:
NumLock:
MultiBoot for HDs:
Boot sequence:
To Next Page
Loading...
Need help?
General