229
PRIMERGY TX150 S4 User’s Guide
8
Configuring Hardware and utilities
8.2.9 Power On/Off Submenu
Use this submenu to configure power On/Off settings.
table: Items on the Power On/Off Submenu
Item Setting Description
Power On Source BIOS Controlled
(Unchangeable)
Configures the power-on setting.
Remote • Disabled (Initial value)
•Enabled
Sets whether or not the power is turned on when
the modem (connected to the serial port) receives
a ring signal.
LAN • Disabled
• Enabled (Initial value)
Sets whether or not to enable the power to be
turned on via LAN.
Wake Up Timer • Disabled (Initial value)
•Enabled
Sets whether or not the power is turned on at a
certain time or after a certain time has passed. A
separate program is necessary for setting startup
time.
Sets the following items if [Wake Up Timer] is
set to [Enabled].
Wake Up Time Sets the startup time when using [Wake Up Timer].
Wake Up Mode • Daily (Initial value)
• Monthly
Sets the startup mode when using [Wake Up
Timer].
Sets dates in [Wake up Day] if [Daily] is selected.
Power Off Source
Software • Disabled
• Enabled (Initial value)
Sets whether or not to enable the power to be
turned off using a program or the operating
system.
Power Button • Disabled
• Enabled (Initial value)
Sets whether or not to allow the use of the power
switch for turning the power off, when the ACPI
function is disabled.
Item Specific Help
Change Values-/+
F7
Select Item
Select Menu
Select Sub-MenuEnter
F1
Esc
Help
Exit
F9
Mod. Defaults
Previous Values
Advanced Security Server ExitMain
Power On/Off
Power-on Source
Remote:
LAN:
Wake up Timer:
Wake up Time:
Wake up Mode:
Power-off Source
Software:
Power Button:
Power Failure Recovery:
[Bios Controlled]
[Enabled]
[Enabled]
[Disabled]
[00:00:00]
[Dally]
[Enabled]
[Enabled]
[Previous State]
To Next Page
Loading...
Need help?
General