295
PRIMERGY TX150 S4 User’s Guide
Appendix
A
C Remote Control Function
This server supports the remote control function.
When a personal computer (PC) is connected to the serial port of this server with an
RS-232C cross cable, the PC can be used to control (turn on/off and reset) the server
power supply.
C.1 Preparation for Using Remote Control Function
To enable the remote control function, perform the following procedure.
• Configuring the BIOS
• Connecting the Server to a PC
• Configuring terminal software communication settings on the PC
■ Configuring the BIOS
To use the function of remote control and console redirection, perform the following setting using the
BIOS Setup Utility.
1 Turn on the server. Press the [F2] key during POST to start up the BIOS Setup
Utility.
2 Select the [Advanced] menu → the [Peripheral Configuration] submenu, and
set [Serial Multiplexer] to [BMC].
3 From the [Exit] menu, select [Saving Changes & Exit] to exit the BIOS Setup
Utility.
To Next Page
Loading...
Need help?
General