11. HOW TO MONITOR ROUTES
11-11
11.8.4 Instant track details
You can see the location and alert type found in an instant track by clicking the [De-
tails] button on the [Instant Track] dialog box.
Note: If the Status is not [OK], an alert (alarm or warning priority, depending on set-
ting) appears in the Alert box.
11.8.5 How to monitor, stop monitoring an instant track route
How to monitor an instant track route
If the route check results is "OK", click the [Monitor] button on the [Planning] page in
the [Instant Track] dialog box to start monitoring the instant track route. Click the but-
ton before the time remaining counts to zero, otherwise the instant track will be can-
celled, followed by the message "Instant track is expiration." After the [Monitor] button
is clicked the [Monitoring] page is opened. The [Monitoring] page shows the name of
the instant track and the instant track mode.
The vessel follows the instant track route in the same method as a monitored route,
which is greyed out to indicate it is inactive. For the instant track route connected to a
monitored route, the previous instant track route is also greyed out to show it is inac-
tive. Any additional instant track routes are erased.
To Next Page
Loading...
Need help?
General
