1. INTRODUCTION
1-6
1.7 How to Select a Color Palette
The system provides three sets of color and brilliance sets (palette), day, dusk and
night, to match any ambient lighting condition. The default specifications of each set
are as shown in the table below. The panel dimmer setting is automatically changed,
and the number of steps depends on the color palette selected.
To select a palette, do the following:
1. Click the [Palette] button.
2. Select [Day], [Dusk] or [Night] as appropriate. For example, select [Day] to show
its options.
3. Click the palette desired.
Note 1: A palette can also be selected by pushing the BRILL control on the Control
Unit.
Note 2: If the display cannot be seen when switching from a Night to Day palette, push
and hold the right button (approx. 2 seconds) to switch to the dusk-gray mode.
Note 3: The color palette setting may not get synchronized among ECDIS units se-
lected for synchronization if a unit is being booted during the selection of the color pal-
ette. If this occurs, wait until all ECDIS units selected for synchronization have booted
then reselect required color palette.
Palette Brilliance
Panel dimmer
(step)
Text
color
Background
color
19”
display unit
23”/27”
display unit
Day-gray
110 cd/m
2
120 cd/m
2
9WhiteGray
Day-blue
110 cd/m
2
120 cd/m
2
9 White Blue
Dusk-gray
50 cd/m
2
50 cd/m
2
8 Light gray Dark gray
Dusk-blue
50 cd/m
2
50 cd/m
2
8 Light gray Dark blue
Night-gray
5 cd/m
2
5 cd/m
2
5 Orange Dark gray
Night-blue
5 cd/m
2
5 cd/m
2
5 Light gray Dark blue
To Next Page
Loading...
Need help?
General
