26. AUTOPILOT OPERATIONS
26-8
FU Override NFU Controller
Starting steering override:
1) Confirm that the Ready lamp in
the NFU controller is ON.
2) Pull out the pin stopper inserted
in the override NFU controller
and turn the lever to the desired
direction. Beeps sounds then
the selected steering mode
flashes. The ON lamp in the
Override reset unit is lit.
3) The rudder is taken when the le-
ver is turned, and the rudder
stops when the lever is returned
to the neutral position.
Stopping steering override:
1) Push the Override steering re-
set switch on the override reset
unit in the steering stand to re-
turn to the previous steering
mode.
2) If the steering mode was AUTO,
the heading at the time the over-
ride steering became active is
set as heading. Auto resume is
disabled if the steering mode
was RC/NAV. To restore the RC
mode, turn the mode selection
switch to another steering mode
then select the RC mode again.
Ready lamp
Override steering
lever
Pin stopper
Override indicator
Override steering
reset switch
Dimmer knob
To Next Page
Loading...
Need help?
General
