To Next Page

To Previous Page

CHAPTER 4: INTERFACES

469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL 4–13

4.2.3 Installing the EnerVista 469 Setup Software

The following minimum requirements must be met for the EnerVista 469 Setup software to

operate on your computer.

• Pentium class or higher processor (Pentium II 400 MHz or better recommended)

• Microsoft Windows 95, 98, 98SE, NT 4.0 (SP4 or higher), 2000, XP

• 128 MB of RAM (256 MB recommended)

• Minimum of 200 MB hard disk space

After ensuring these minimum requirements, use the following procedure to install the

EnerVista 469 Setup software from the enclosed GE EnerVista CD.

Z Insert the GE EnerVista CD into your CD-ROM drive.

Z Click the Install Now button and follow the installation instructions to

install the no-charge EnerVista software on the local PC.

Z When installation is complete, start the EnerVista Launchpad

application.

Z Click the IED Setup section of the Launch Pad window.

Z In the EnerVista Launch Pad window, click the Add Product button

and select the “469 Motor Management Relay” from the Install

Software window as shown below.

Z Select the “Web” option to ensure the most recent software release, or

select “CD” if you do not have a web connection.

GE 469 User Manual

Other manuals for GE 469