GE LOGIQ 100 PRO User Manual

GE HEALTHCARE
D
IRECTION 5305880-100, REVISION 3 LOGIQ™ 100 PRO SERVICE MANUAL
Chapter 10 - Quality Assurance Page 10-1
Chapter 10 Quality Assurance
Section 10-1 Overview
10-1-1 Purpose of Chapter 10
This chapter describes Quality Assurance & Periodic Maintenance (PM) on the scanner and its
peripherals. These PM procedures are intended to maintain the quality of the ultrasound systems
performance. Read this chapter completely and familiarize yourself with the procedures before
starting a PM.
CONTENTS IN CHAPTER 10
Section Description Page Number
10-1
Overview
10-1
10-2
Why do Periodic Maintenance
10-2
10-3
Periodic Maintenance Schedule
10-2
10-4
Tools Required
10-4
10-5
System Periodic Maintenance
10-7
10-6
Electrical Safety Tests
10-11
10-7
When There's Too Much Leakage Current...
10-23
PM Inspection Certificate
10-29
Table 10-1 Contents in Chapter 10
Practice good ESD prevention. Wear an anti–static strap when handling electronic parts and
even when disconnecting/connecting cables.
THERE ARE SEVERAL PLACES ON THE REAR PANEL THAT ARE
DANGEROUS. BE SURE TO DISCONNECT THE SYSTEM POWER PLUG AND
OPEN THE MAIN CIRCUIT BREAKER BEFORE YOU REMOVE ANY PARTS. BE
CAUTIOUS WHENEVER POWER IS STILL ON AND COVERS ARE REMOVED.
Do not pull out or insert circuit boards while power is ON.
Do not operate this unit unless all board covers and frame panels are securely in place. System
performance and cooling require this.
State: RELEASE - Document is released and under formal Change Control. Changes are subject to the ECR/ECO Process. See the GEHC Myworkshop System to determine the status of this document.
Approved Document - 5305880-100TPH_r3.pdf Page 172 of 197

GE LOGIQ 100 PRO Specifications

General

Brand	GE
Model	LOGIQ 100 PRO
Category	Medical Equipment
Language	English