EasyManuals Logo
Home>GE>Medical Equipment>LOGIQ 100 PRO

GE LOGIQ 100 PRO User Manual

GE LOGIQ 100 PRO
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
GE HEALTHCARE
D
IRECTION 5305880-100, REVISION 3 LOGIQ™ 100 PRO SERVICE MANUAL
Chapter 1 - Introduction Page 1-3
Section 1-2 Safety
1-2-1 Warnings
WARNING CAREFULLY READ ALL THE WARNINGS BELOW
1.) The operator manual should be read and understood before operating the LOGIQ™ 100
PRO and kept nearby for quick reference.
2.) Although the ultrasound energy transmitted from the LOGIQ™ 100 PRO transducer is
within AIUM/NEMA standards, unnecessary exposure should be avoided. Only trained
personnel should operate the LOGIQ™ 100 PRO.
3.) To prevent electric shock, the LOGIQ™ 100 PRO should be connected to a properly
grounded power receptacle.Do not use a three prong to two prong adapter. This defeats
safety grounding/
4.) Probes are fragile, Please handle with care.
5.) Concerning outside markings, refer to Figure 1-2 through 1-3.
6.) For the cleaning, disinfection, and sterilization, refer to Probe section in LOGIQ™ 100
PRO User Manual and Caution Sheet supplied with each probe.
NOTICE This medical equipment is approved, in terms of the prevention of radio wave interference,
to be used in hospitals, clinics and other institutions which are environmentally qualified. The use
of this equipment is an inappropriate environment may cause some electronic interference to radios
and televisions around the eqiupment. Proper handling of this equipment is required in order to
avoid such trouble according to the operator and service manuals. This eqiupments can be used in
residential areas only under the supervision of physicians and qualified technicians.
CAUTION Improper performance possibility. Do not use the following devices near this
equipment. Cellular phone, radio transciever, mobile radio transmitter, radio-controlled toy,
etc. Use of these devices near this equipment could cause this equipment to perform outside
the published specifications. Keep power to these devices turned off when near this
equipment.
State: RELEASE - Document is released and under formal Change Control. Changes are subject to the ECR/ECO Process.
See the GEHC Myworkshop System to determine the status of this document.
Approved Document - 5305880-100TPH_r3.pdf Page 20 of 197

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE LOGIQ 100 PRO and is the answer not in the manual?

GE LOGIQ 100 PRO Specifications

General IconGeneral
BrandGE
ModelLOGIQ 100 PRO
CategoryMedical Equipment
LanguageEnglish

Related product manuals