GE LOGIQ 100 PRO User Manual

GE HEALTHCARE
D
IRECTION 5305880-100, REVISION 3 LOGIQ™ 100 PRO SERVICE MANUAL
Page 4-6 Section 4-1 - Overview
4-3-2 Basic Controls
Table 4-2 describes basic controls which helps in checking the LOGIQ™ 100 PRO during
installation.
Connect the sector or convex transducer to connector on the right side of the base.
TASK Expected Result
Turn `ON' Power Switch B-Mode screen as in figure 4-3should appear
Press New Patient Key
Press ID/Name
A pop-up window appears. Enter Patient Name/ID. It
presets the system
A pop-up window appears. Enter Patient Name/ID. It
does not preset the system.
Press Dyn Range Up/Down Image grows softer and harder depending on position.
Rotate Gain Knob Image grows lighter and darker with rotation.
Press Reverse
Press Reverse a second time
Press SHIFT + Reverse
Press SHIFT+ Reverse a second
time
The image will be displayed Left/Right
The image will be displayed Right/Left.
The image will be displayed Top/Bottom
The image will be displayed Bottom/Top
Press M key
Roll Trackball
Press M key a second time
B/M Mode with M-line cursor appears. (Use trackball to
move the M-line cursor). Refer Figure
4-4
The M-Line cursor should follow the trackball movement
and the real-time image varies on the M-Mode display.
Only M-Mode image appears on the screen.
Press B Mode Key to exit M-Mode.
Press Freeze key The image will freeze.
Press ATO ATO, Automatic Tissue Optimization, optimizes the
image based upon a specified Region Of Interest (ROI)
or anatomy within the display. ATO Gray scale map is
available only in B-Mode.
Press Freeze and Zoom
Roll Trackball
Zoom is used to magnify an image. The magnification
factor for zoom is fixed at 2.0. The system adjusts all
imaging parameters accordingly.
To select the ROI for Zoom
Zoom feature is avialable in the freezed mode only.
Table 4-2 Basic Controls
State: RELEASE - Document is released and under formal Change Control. Changes are subject to the ECR/ECO Process. See the GEHC Myworkshop System to determine the status of this document.
Approved Document - 5305880-100TPH_r3.pdf Page 81 of 197

GE LOGIQ 100 PRO Specifications

General

Brand	GE
Model	LOGIQ 100 PRO
Category	Medical Equipment
Language	English