GE MEDICAL SYSTEMS
DIRECTION 2300000, REVISION 2 LOGIQ™5 SERVICE MANUAL
4-14 Section 4-3 - General Procedure
4-3-10 Using the CD-RW / MOD (Magneto-Optical Drive)
4-3-10-1 Using the CD-RW
1.) Push the EJECT
button, the disk tray will appear.
2.) Put the disk onto the disk tray.
3.) Press the EJECT
button to insert the disk into the CD-RW device.
4.) There are a number of methods to eject a disk from the CD-RW. Ejection is automatic in some
cases. Manual ejection methods, listed in preferred order of use, are:
a.) Press EJECT
button on the CD-RW while system is ON.
b.) Press and hold EJECT
button while the system is booting.
c.) Mechanical ejection. Insert the end of a paper clip into the hole next to the EJECT button while
system power is OFF.
NOTICE
Never move the unit with a disk in the CD-RW because the drive actuator will not be locked
and the CD-RW could break.
NOTICE
Avoid mechanical ejection whenever possible. Mechanical ejection leaves the actuator
unlocked and the MOD susceptible to damage if moved. If forced to use this method, reboot
the system, then insert and eject a known good disk using one of the other methods.
Figure 4-9 CD-RW drives
CD-RW Drive
Eject Button
To Next Page
Loading...
Need help?
General
